“Finite Element Analysis of Antenna Positioner Unit”
It is the defense application product used to move the Antenna in both Azimuth and Elevation axes to relay critical communication data.
The Static Structural analysis for a given payload condition, Modal analysis for a given frequency range, Steady state thermal analysis and wind analysis is successfully simulated using numerical software to ensure the safety of the product.
“Design for the Development of 5m Electro mechanical Telescopic Mast”
It is the new product development project used for military applications.
The product is mount on vehicle used to erect and measure the communications data at an any desired location.
The agile design and the numerical analysis are carried out to ensure the compatibility of the product and the analysis are listed as follows, Static Structural analysis for a given payload condition, Harmonic analysis, Steady state thermal analysis at extreme boundary conditions and wind analysis.
“Stability review of the drive system for aerial view tower”
It is the theme park project where the giant wheel moves up and down around the tower.
Static structural analysis for a given payload condition with applied counter weight and modal analysis for a given frequency range is carried out to ensure the safety of drive system for the aerial view tower
“Design and Development of 167 m Wind Mast”
It is new product development project. The Wind mast is erected at specific geographic locations (sites) to measure the wind flow data and estimate electrical power production.
The selected conceptual design is modelled and simulated to ensure the erection mechanism.
After finalized the mechanism, the wind analysis at a given wind speed, static structural analysis for a given payload condition is carried out to ensure the compatibility of the product.
”Finite element analysis of GIS structures”
It is the numerical simulation project carried out for structural, wind, modal, seismic and thermal analysis of a structures.
Gas Insulated Substation (GIS) is a high voltage substation in which the major conducting structures are contained within a sealed environment with a dielectric gas known as SF6, or sulphur hexafluoride gas as the insulating medium, there was a critical need to develop substations with a greatly reduced footprint.
“CFD analysis of the flow pattern of milk in the nipple design created”
It is the CFD project to capture the effect of the flow pattern of the milk fluid inside the product.
Also, maximum velocity and pressure at outlet is numerically calculated.
Another CFD analysis project entitled “CFD Analysis in Sewer line” is carried out to ensure the maximum velocity flow at outlet to avoid the accumulation of sewage water in the given design.
“Power Generation Using Watch Escapement Mechanism”
It is new product development project used to generate electric power from the mechanized work.
This product is designed to ensure to meet the power requirement of future needs.
The concept generation and selection are carried out followed by dynamic analysis of the mechanism.
The estimated output power generated from the product is approximately 10 Watts.
“Design of Instrument enclosure for PCB”
It is the 3D printing project designed to meet the compact assembled size of the components. In this project the multiple parts are consolidated into single part.
Also, Industrial design is carried out to make the product aesthetics.